DA-88 FAQ For Software v4.01
Revised: Greg Loskorn 3/27/99
- Tape Formatting:
- Press "Format" twice
- Press "Fs" to select Sample Rate
- Press "Record" then "Play"
- Stripe Time Code:
- Press "Display" til "TC" LED lights
OR
- Press "Display" then down arrow
THEN
- Press up & down to open T.C. window
- Press up or down for desird TC type
- Set time:
- Press "Display" til "GEN" LED lights
- Press up & down then "Display" (Hr)
- Press "Display" (Min)
- Press "Display" (Sec)
- Press "Display" (Fr)
- Press "Display" to end
- Record Time Code:
- Press "TC Rec"
- Press "TC Gen"
- Press "Record" then "Play"
- Display Incoming Time Code:
- While in T.C. display window,
- Press up arrow & "Display"
- "TC" Led will flash to indicate incoming code.
|
ADAT XT Error Codes
Revised: Greg Loskorn 3/27/99
- -du-
- Too humid
- noFO
- No Format on tape
- Protect
- Tape is write protected
- -FO-
- Rewinding to beg. to format
- FULL MIDI
- input buffer overflow
- Error 0
- Loading: No plate down swi
- Ejecting:
- No tape ins swi
- Error 1
- Didn't see mode 1 swi.
- Error 2
- Didn't see mode 2 swi.
- Error 3
- Didn't see mode 2 and 3 swi.
- Error 4
- Drum not spinning
- Error 5
- Drum PG period not valid
- Error 6
- Invalid data or checksum
- Error 7
- Bad write sector
- Error 8
- Sync. lost while Rec.
- Error 9
- No tach pulses
- Error 10-13
- (not used)
- Error 14
- Crossfade buffer error
- Error 15
- Crossfading state error
- Error 16
- (not used)
- Error 17
- End Sensor Error
|
|
Back To Home Page
Back Up To The Top